To Light The Burner; To Extinguish The Burner - AGA GC3 User Instructions

SEE FIGS 2 & 3
CAUTION: BEFORE LIGHTING: ENSURE THAT THE GAS VALVE CONTROL KNOB (2) IS
SET IN THE OFF POSITION.
1. Turn on gas supply to cooker and open gas cock 1 at the base of the gas valve.
2. Turn the gas valve control knob 2 anti-clockwise to the position (
down firmly and hold the knob in this position while depressing the piezo ignitor 3 several
times until the pilot has lit. This can be observed through the burner housing aperture.
3. When the pilot has lit continue to hold the gas valve control knob down for approx. 30
seconds. If it goes out, wait three minutes and repeat the procedure holding for a little
longer.
4. With the pilot flame established, rotate the gas valve control knob 2 anti-clockwise to its low
fire position (see Fig. 3C). Where upon the main burner will automatically light. Leave in the
low fire position for at least 30 minutes.
5. After 30 minutes rotate the control knob further anti-clockwise to the mid-position of the
green band for normal running (see Fig. 3D).
NOTE: AFTER SEVERAL HOURS THE HEAT INDICATOR SHOULD BE ON OR ABOUT THE
CENTRE OF THE SILVER SECTION. IT MAY BE NECESSARY TO ADJUST THE CONTROL
KNOB SLIGHTLY IN THE GREEN BAND TO ACHIEVE THIS.
When the cooker is lit from cold, moisture may form on the enamel which should be wiped off to
prevent staining.
IF THE FLAME HAS EXTINGUISHED FOR WHATEVER REASON, WAIT THREE MINUTES
(MINIMUM) BEFORE RE-LIGHTING.
SHOULD THE FLAME REPEATEDLY EXTINGUISH CALL YOUR LOCAL AGA DEALER.
NOTE: REMEMBER TO NOTE THE SETTING OF THE GAS VALVE CONTROL KNOB 2
PRIOR TO EXTINGUISHING THE BURNER
Turn the gas valve control knob clockwise to the off position (See Fig. 3A).
Frost Precautions
In the event of the cooker being switched OFF for long periods during very cold weather, the
advice of the Local Gas Region or Aga Distributor should be obtained.

TO LIGHT THE BURNER

TO EXTINGUISH THE BURNER

5
) (see Fig. 3B). Press