Horizon Fitness E51 Service Manual page 51

12. Locate the c-clip (R34) on the left-hand side of the crank assembly
axle, and remove the c-clip with a snap ring pliers.
13. Tap the crank assembly (R01) from the frame, pounding on the left-
hand side towards the right.
14. Once the crank assembly and the bearings are removed from the
frame, make sure to remove all dirt or grease from the frame bearing
housing.
15. Insert new crank assembly and bearings. Make sure that bearing loct-
tite is applied to both the inner and outer diameter for both the left and
right bearings. Note: It is helpful to insert the right side bearing and
crank pulley first. Once the right bearing and the crank pulley are in
place, carefully tap the left bearing into position. It is best to let the
loctite set for 24 hours before using the elliptical.
16. Attach the c-clip (R34) in place on the crank assembly.
17. Attach the right side cover, crank arm, crank disk and black cap in
that order Attach the wood grain accent piece.
18. Attach the left side cover, crank arm, crank disk and black cap.
19. Slide console mast boot back into place.
20. Attach the right and left pedal arms onto each crank arm. Replace nut
attaching pedal arm to crank arm (using 17mm wrench).
21. Reattach the crank arm covers.
22. Attach the lower handlebar links to each pedal arm.
23. Test ride elliptical to make sure it is working correctly.
51