Horizon Fitness E51 Service Manual page 49

17. Connect the tension knob cable to the flywheel/brake assembly.
18. Slide the tension cable through the bracket on the main frame. Secure
by tightening the two 10mm nuts.
19. The proper resistance setting is set when the magnetic brake is 2-3
mm from the flywheel at the highest resistance setting.
20. Adjust the tension knob from the lowest to highest resistance settings
to ensure proper movement and position of the flywheel/brake
assembly.
21. Attach the left side cover and secure with screws.
22. Attach the accent piece, placing the bottom tab into position first then
placing the top tab into position.
23. Slide console mast boot back into place.
24. Attach the crank disk and crank arm to the crank axle. Place black
cap onto the center of the crank disk.
25. Attach pedal arm onto crank arm. Replace nut attaching pedal arm to
crank arm (using 17mm wrench).
26. Replace pedal arm cap.
27. Attach the lower handlebar to the pedal arm and secure with nut and
washers.
28. Attach the lower handlebar to the lower link arm using the 13mm nut
and associated bolt.
49