Replacing The Internal Speaker - Lenovo ThinkStation P700 Hardware Maintenance Manual

2. Gently press down the small handle
down the small handle
Figure 132. Securing the microprocessor in the socket
1
3. Align the notch of the microprocessor socket cover with the alignment key
socket. Lower the socket cover straight down into the microprocessor socket on the system board.
Figure 133. Installing the microprocessor socket cover
Note: Your microprocessor socket and cover might look slightly different from the illustration.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 198.

Replacing the internal speaker

Attention: Do not open your computer or attempt any repair before reading and understanding the Chapter
1 "Read this first: Important safety information" on page 1.
To replace the internal speaker, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Remove the computer cover. See "Removing the computer cover" on page 111.
1 , and then push the handle inward to secure it. Then gently press
2 and push the handle inward to lock the microprocessor retainer into position.
2
of the microprocessor
.
Chapter 11 Installing or replacing hardware
187