Replacing The Power Supply Assembly - Lenovo ThinkStation P700 Hardware Maintenance Manual

8. Connect the SAS cable to the SAS connector on the RAID card.
9. Connect the power cable to the 4–pin power connector on the system board. See "Locating parts on
the system board" on page 35.
10. If your blind-connect assembly comes with two additional cables
2
connectors on the flex adapter as shown.
Figure 92. Connecting the blind-connect assembly to the flex adapter
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 198.

Replacing the power supply assembly

Attention: Do not open your computer or attempt any repair before reading and understanding the Chapter
1 "Read this first: Important safety information" on page 1.
Although there are no moving parts in your computer after the power cord has been disconnected, the
following warnings are required for your safety and proper Underwriters Laboratories (UL) certification.
CAUTION:
Hazardous moving parts. Keep fingers and other body parts away.
CAUTION:
Never remove the cover on a power supply or any part that has the following label attached.
158
ThinkStation P500 and P700 Hardware Maintenance Manual
1 , connect them to the two PCIe