Lenovo ThinkStation P700 Hardware Maintenance Manual page 121

3. Remove the direct cooling air baffle. See "Removing and reinstalling the direct cooling air baffle" on
page 112.
4. Locate the optical drive bay that you want to use. See "Locating components" on page 32.
5. Depending on whether you are installing or replacing an optical drive, do one of the following:
• If you are installing a new optical drive, press the clip on the bottom of the optical drive bay from
the front of the computer to remove the plastic cover. If there is a metal static shield installed in the
optical drive bay, remove the metal static shield.
• If you are replacing an old optical drive, disconnect the signal cable and the power cable from the
rear of the optical drive. Then, press the tabs
push the rear of the optical drive to slide it out of the computer.
Note: If you are replacing a flex module or a front-access storage enclosure, remove any additional
cables first.
Figure 16. Removing the optical drive
1 toward each other as shown, and at the same time
.
Chapter 11 Installing or replacing hardware
115