Charging The Battery - Derby cycle IMPULSE 2.0 SPEED Owner's Manual

DOWN TUBE BATTERY
Removing the battery
3. You should now remove the key and keep it in a safe
place to prevent it from breaking off or being lost.

5.1.2 Charging the battery

Before charging the battery, read the information
on the charger carefully.
1. a) Down tube battery: Take the charger provided out
of its packaging and plug it in at the wall socket.
b) Seat tube battery: Take the charger provided and
the docking station out of their packaging and plug the
mains plug into a socket. Connect the charger to the
docking station. The LED in the charger now lights up
red briefly, then changes to steady green.
To charge the battery safely, the charger must be
placed on a suitable surface, which should be dry
and non-flammable.
Seat tube battery: The charger must stand on its
four feet. This is essential to ensure that the hot
air from the ventilation slots can dissipate.
2. a) Down tube battery: Connect the plug of the charger
to the battery.
b) Seat tube battery: Put the battery in the holder of
the docking station. The LED in the charger lights up
green.
SEAT TUBE BATTERY
SEAT TUBE BATTERY
Charging the battery
3. a) Down tube battery: Charging begins. If your charger
has an LED, it lights up red. The battery is charged in
five stages. When charging of one stage is in progress,
the corresponding LED flashes. When this stage has
been fully charged, the LED stops flashing and stays
lit. Now the next LED will begin to flash. After all five
LEDs have gone out, the battery is fully charged.
b) Seat tube battery: Charging begins. The LED of the
charger lights up green. The battery LEDs light up one
by one to indicate the progress of charging. The bat-
tery is charged in five stages. When charging of one
stage is in progress, the corresponding LED flashes.
When this stage has been fully charged, the LED stops
flashing and stays lit. Now the next LED will begin to
flash. After all five LEDs have gone out, the battery is
fully charged.
If your charger has an LED, and it flashes red con-
tinuously, this indicates a charging fault. Have the
charger and battery checked by your specialist
cycle shop.
4. Unplug the charger at the wall socket once charging is
complete.
Damaged batteries must not be charged, and fur-
ther use is not permitted.
The battery may heat up during charging. A maxi-
mum temperature of 113 °F may be reached. If
the battery becomes any hotter than this, stop the
charging process immediately.
Original User Manual | Pedelec Impulse 2.0 speed 47