Control Unit And Display; Control Unit; Switching On/Off; Pushing Assistance - Derby cycle IMPULSE 2.0 SPEED Owner's Manual

7 Control unit and display

The Pedelec Impulse Speed 2.0 can be controlled via the
control unit on the handlebar grip and the display in the
middle of the handlebar.
7.1

Control unit

1
2
3
4
1 button, on and off button
2 button, increase value/scroll up
3 button, decrease value/scroll down
4 button
Press the button to switch the system on and off. But-
tons 2 to 4 have different functions depending on the
menu item you have selected.
52 Original User Manual | Pedelec Impulse 2.0 speed

7.1.1 Switching on/off

Press the button on the control unit to switch the Im-
pulse system on. After a few seconds, the welcome screen
appears, followed by the start menu. From there you can
carry out further settings ➠ 7.3 Programming and settings.
After switching on, the system is always in the
same display mode as when you last switched it
off.
To switch your Pedelec off, press the
trol unit.

7.1.2 Pushing assistance

The pushing assistance moves the Pedelec slowly (at a
maximum speed of 12,43 mph) without you having to
pedal, e.g. if you are manoeuvring in a tight space or are
pushing your S-Pedelec out of a basement garage.
To activate the pushing assistance, press the
three seconds.
The pushing assistance is suitable for starting up
from standstill.
7.1.3

/ buttons

• You can specify the power-assist level via the
buttons.
• Each time you press one of these two buttons, the
power assist changes by one level. If you press the
button once, the level of assistance increases by
one level. If you press the
sistance becomes weaker by one level.
button on the con-
button for
/
button once, the as-