Table of Contents
Advertisement
far as is
possible towards the cable exit from the motor axle, being careful not to
damage the cable.
3.10.6 Lift the wheel from the frame dropouts, being careful not to snag or strain the
motor cable.
3.10.7 Installation is the reverse of the above. Take care to locate the tab washers
correctly in the
the manual. Reconnect the two halves of the quick release connectors, taking care to
ensure the pins and alignment
ensuring that the cable cannot rub against the tyre and that the cable exits in a
downwards direction from the axle to avoid
rubber top hat cover.
Because the bicycle has a rear derailleur, the chain will be automatically adjusted.
3.11. Derailleur and gear change
3.11.1 Full details on how to adjust and maintain your derailleur can be found in the
Shimano
manual.
If difficulty is experienced with changing gear after initial operation of the bicycle,
it is likely
that some cable stretch will have occurred in the gear change cable. To
compensate for this turn the knurled adjuster shown in the centre left hand side of the
image below by pulling it
towards the rear of the
the rear. This will compensate
operation again until smooth gear selection is
Wisper dealer for further adjustment.
3.11.2 To change gear, use the 9 speed rapid fire gear shifter located on the right side of
the
handlebar. The two levers located underneath the shifter can be pulled and
pushed to
select the gears over the range 1 to 9.
4. Warranty, battery maintenance and user responsibilities
Repair or replacement of components
IMPORTANT! To validate this warranty, the retail customer must register the bike at
www.wisperbikes.com within 14 days of purchase.
Only use this product in accordance with this user manual. Wisper offer a limited warranty
on the following items.
Main frame
Motor shell, Hub motor, Controller and Charger
Electronic handle bar controls and electrical
connections
drop out slots and tighten the axle nuts to the torque specified in
arrows align correctly. Re-clip the cable to the frame,
away from the outer cable stop in the direction of the cable
bicycle and turning it ½ turn anticlockwise when viewed from
for the cable stretch. If necessary, repeat the
water ingress into the motor. Refit the
obtained or return your bicycle to your
Six years
Two years
Two years
19
Advertisement
Table of Contents
