Table of Contents
Advertisement
Table 9 Network Setting > Broadband > Add New WAN Interface/Edit (ADSL/VDSL over PTM -
Bridge or Ethernet Mode) (continued)
LABEL
DESCRIPTION
802.1q
Type the VLAN ID number (from 0 to 4094) for traffic through this connection.
OK
Click OK to save your changes.
Cancel
Click Cancel to exit this screen without saving.
If you select ADSL over ATM as the interface type, the following screen appears.
Figure 25 Network Setting > Broadband > Add New WAN Interface/Edit (ADSL over ATM-Bridge
Mode)
The following table describes the fields in this screen.
Table 10 Network Setting > Broadband > Add New WAN Interface/Edit (ADSL over ATM-Bridge
Mode)
LABEL
DESCRIPTION
General
Name
Enter a service name of the connection.
Type
Select ADSL over ATM as the interface that you want to configure. The VMG uses the ADSL
technology for data transmission over the DSL port.
Mode
Select Bridge when your ISP provides you more than one IP address and you want the
connected computers to get individual IP address from ISP's DHCP server directly. If you
select Bridge, you cannot use routing functions, such as QoS, Firewall, DHCP server and
NAT on traffic from the selected LAN port(s).
ATM PVC Configuration (These fields appear when the Type is set to ADSL over ATM.)
VPI
The valid range for the VPI is 0 to 255. Enter the VPI assigned to you.
VCI
The valid range for the VCI is 32 to 65535 (0 to 31 is reserved for local management of ATM
traffic). Enter the VCI assigned to you.
Chapter 6 Broadband
VMG1312-Bx0D User's Guide
70
Advertisement
Table of Contents
