Time Setting; Initial Start-Up - Siemens SN SERIES Instruction Manual

en Getting to know your appliance

Time setting

When the appliance is switched on the
T i m e s e t t i n g
for the first time, the time starts at 12:00
o'clock.
Set the time as follows:
Open the door.
1.
Switch on ON/OFF switch (.
2.
Press Info button { 8 for 3
3.
seconds until the following text is
indicated on the display window at
the top @:
Scroll with < >
Set with - +
Leave with Setup 3 sec.

Initial start-up

When the dishwasher is switched on for
the first time, you are taken directly to
the settings for the initial start-up.
If you select Home Connect
Note:
during the initial start-up, make further
settings via your dishwasher App.
Observe the supplied Home Connect
documents.
On the display window at the top @
the following text appears for manual
selection:
Initial start-up settings
Sprache/Language
Home Connect
Time format
Time setting
Water hardness
* depending on the features of your dishwasher
12
Factory setting
Deutsch
Manual/Home Connect
24 h
12:00
°E 16 - 20 medium
Keep pressing button > )R until the
4.
time setting is indicated on the
display window at the top @.
Make the setting with setting buttons
5.
+ - X. If the selection buttons + -
X are held down, the set values
are changed in 10-minute steps.
Press and hold the Info button {
6.
8 for 3 seconds.
The chosen setting has now been
stored.
If the appliance was
Note:
disconnected from the power supply for
a prolonged period, the time starts at
12:00 o'clock. Set the time.
Scroll with < >
Set with - +
Leave with Setup 3 sec.
The required settings for the initial
start-up are listed in the table below.
To change the setting:
Keep pressing button >)R until the
1.
required setting is displayed.
Change the setting with setting
buttons + -X.
Press and hold the Info button {
2.
8 for 3 seconds.
The chosen setting has now been
stored.
Infotext
by pressing Info button {
Language selection.
Manual/Home Connect.
12h or 24h.
Set the current time.
Adjustment to the local water hardness.
When using Multitabs, select setting 0 - 6.