Download Print this page

Siemens SN SERIES Instruction Manual page 44

Hide thumbs

Advertisement

en Fault, what to do?
Fault
Utensils not dry.
Plastic utensils not dry.
Cutlery not dry.
Appliance interior wet after
rinse cycle.
44
Cause
No or too little rinse aid in the
dispenser.
Programme selected without
drying.
Water collecting in depressions
on the utensils and cutlery.
The combined detergent used
has a poor drying performance
ExtraDry to increase drying not
activated.
Utensils were removed too early
or drying process had not ended
yet.
The eco rinse aid used has a
limited drying performance.
Special properties of plastic.
Cutlery not arranged properly in
the cutlery basket.
Cutlery not arranged properly in
the cutlery drawer.
No appliance fault.
Remedial action
Refill rinse aid.
Select programme with drying.
~ "Overview of programmes"
on page 30
Arrange utensils in a sloping position,
arrange affected utensils as sloping as
possible.
Use different combination detergent with
better drying performance. Use of rinse
aid also increases the drying performance.
Activate ExtraDry. ~ "extraDry"
on page 34
Wait until program ends or wait until 30
min after program ends before removing
utensils.
Use a proprietary rinse aid. Eco products
may have limited effectiveness.
Plastic has a lower heat storage capacity
and therefore dries less well.
Separate cutlery if possible, prevent
contact points.
Arrange cutlery properly and separate if
possible.
On account of the "Condensation drying"
principle, water droplets are physically
induced and required in the container. The
humidity in the air condenses on the inner
walls of the dishwasher, drains and is
pumped out.

Hide quick links:

Advertisement

loading

  Also See for Siemens SN SERIES

This manual is also suitable for:

Sx seriesSxxxxSnxxx