Panasonic VL-SWD501 Installation Manual page 32

Installing Wireless Sensor Cameras
Installing Wireless Sensor Cameras
Step 6
Adjusting the wireless sensor camera angle.
Screw (1)
Screw (2)
Turn on the wireless sensor camera, monitor
Step 7
the wireless sensor camera image, confirm
the viewable area and the wireless sensor
camera audio.
•If you're not satisfied with the viewable area,
adjust the camera angle and confirm the
results.
•If the Video Intercom System includes a sub
monitor, take it to the camera installation
location and confirm the image displayed on
the sub monitor while adjusting the camera
angle as necessary.
Adjusting angle left
and right:
1 Loosen screw (1) and
adjust the angle left or right.
2 Tighten screw (1)
Adjusting angle up
and down:
1 Hold the wireless sensor
camera in one hand and
loosen screw (2) to adjust
the angle up or down.
2 Tighten screw (2).
After you have adjusted the angle, attach
Step 8
the safety wire to the wall.
Mounting screw
•Attach the safety wire high on the wall so that
the wireless sensor camera does not strike
anyone in the event the wireless sensor camera
becomes detached from the wall.
•Do not hang from the wireless sensor camera.
Step 9 Test the sensor detection and image
recording.
Washer
Safety wire