Panasonic VL-SWD501 Installation Manual page 18

Main Monitor Station Installation
Main Monitor Station Installation
Installing the main monitor station
Step 2
Connect the DC cable and wires.
How to connect the DC cable:
1
Remove screw A and then remove the terminal cover.
2
Loosen screw B and push in the wires of the DC cable
to the terminal connectors (non-polar), then tighten the
screws.
Bare wire at tip
12 mm
32 mm
3
Use the cable binder to secure the DC cable (double-
coated area) to the main monitor station.
4
Make sure to replace the terminal cover.
Mount the main monitor station to the mounting
Step 3
bracket.
1
Line up the tab on the bottom of the bracket with the
groove on the main monitor station (1).
2
Line up the tab on the top of the bracket with the groove
on the main monitor station, and push the main
monitor station down until it is secure (2).
Screw B
Cable binder
How to make wiring connections:
While pressing on the button with a
pointed object such as a screwdriver,
insert the wire into the terminal
connector. (To disconnect a wire,
while pressing on the button, pull out
the wire.)
Screws A
(1)
Terminal Button
Bare wire at tip
9 mm
9 mm
Wiring from
door station
(2)