Table of Contents
Advertisement
A.1.3 LED WLAN
The WLAN LED on the front panel does not light up.
Steps
1
2
3
A.2 WEB
I cannot access the web configurator.
Steps
1
2
3
The web configurator does not display properly.
Steps
1
2
A.3 Login
If you forget the password to log in
Steps
Press the "Reset" button on the rear panel of the AP, to set back to
factory default setting.
Please unplug AC Adaptor and replug-it.
If these steps fail to correct the problem, contact your local
distributor for assistance.
Make sure you are using the correct IP address of the Wireless
Multi-Function Access Point. Check the IP address of the Access
Point (192.168.1.1).
Check Mac Filtering (on Security). Access Control function allows
clients whose MAC addresses in the list will be able to connect to
this Access Point. When this function is activate, there is no
wireless clients will be able to connect to the Access Point unless
they are listed in the Access Control list.
Press the "Reset" button on the rear panel of the AP, to set back to
factory default setting.
Make sure you are using Internet Explorer 5.0 and later versions.
Delete the temporary web files and log in again.
In Internet Explorer, click Tools, Internet Options and then click the
Delete Files ... button.
When a Delete Files window displays, select Delete all offline
content and click OK. (Steps may vary depending on the version of
your Internet browser.)
CORRECTIVE ACTION
CORRECTIVE ACTION
CORRECTIVE ACTION
CORRECTIVE ACTION
57
Advertisement
Table of Contents
