Chapter 3: Configuration; Before Configuration - Atlantis Land NetFly AP1-54/P Manual

Eee 802.11g wireless lan access point

Hide thumbs Also See for NetFly AP1-54/P:

Table of Contents

3. CHAPTER 3: Configuration

The Wireless Access Point has a Web GUI interface for the configuration. The AP can

be configured through the Web Browser. A network manager can manage, control and

monitor the AP from the local LAN. This section indicates how to configure the AP to

enable its functions.

This section describes the configuration required by LAN-attached PCs that

communicate with the Wireless Access Point, either to configure the device or for

network access. These PCs must have an Ethernet interface (or wireless adapter)

installed properly, be connected to the Wireless Access Point either directly or through

an external repeater hub or by wireless, and have TCP/IP installed and configured with

a fixed IP address that must be in the same subnet of the Wireless Access Point. The

default IP address of the Wireless Access Point is 192.168.1.1 and subnet mask is

255.255.255.0.

Please follow the steps below for PC's network environment installation. First of all,

please check your PC's network components. The TCP/IP protocol stack and Ethernet

network adapter must be installed. If not, please refer to MS Windows related

manuals.

Any TCP/IP capable workstation can be used to communicate

with or through the Wireless Access Point to configure other

types of workstations, please consult the manufacturer's

documentation.

Table of Contents