2.4 Cabling and setup
Connect to the Switch/Hub
Plug in one end of the RJ45 network cable to the Switch/Hub port,
Plug in the other end of the RJ45 network cable to the Wireless Access Point.
Check the installation
The LEDs of the Access Point are clearly visible and the status of the network link can
be seen instantly:
With the power source on, once the device is connected, the Power, LAN and WLAN
port LEDs will light up indicating a normal status.
If the LAN Port's Link indicator does not light up then check the RJ-45 cable if it is
firmly feed to the RJ45 port, while the LAN is link up to the Switch/Hub, the LAN port's
LED will light up.
15