Using The Side Discharge - Toro TITAN ZX 4800 Operator's Manual

12. Remove the 2 locknuts (5/16 inch) securing the welded
posts of the right baffle to the top of the mower deck
at center and right of center positions
2
Figure 34
1. Locknut (5/16 inch)
2. Right baffle
13. Remove the carriage bolt and locknut securing the right
baffle to the top of the mower deck and remove the
right baffle from the mower deck
14. Install the fasteners removed previously at the front
holes in the discharge plate and forward hole in the
deck (Figure 33).
15. Locate the cutoff baffle in the loose parts bag, remove
the fasteners at the rear holes of the discharge plate,
and install the baffle at the side-discharge opening on
the mower deck (Figure
Figure 35
1. Carriage bolt
2. Rear holes in the
discharge plate
(Figure 34).
G010704
3
3. Welded posts, right baffle
4. Carriage bolt
(Figure 34).
35).
3. Cutoff baffle
4. Locknut
16. Use the fasteners removed to secure the cutoff baffle
to the deck.
17. Install the mower; refer to
(page 49).
1

Using the Side Discharge

The mower has a hinged grass deflector that disperses
clippings to the side and down toward the turf.
DANGER
Without a grass deflector, discharge cover, or
complete grass catcher assembly mounted in
place, you and others are exposed to blade contact
and thrown debris. Contact with rotating mower
blade(s) and thrown debris will cause injury or
death.
• Never remove the grass deflector from the mower
because the grass deflector routes material down
toward the turf. If the grass deflector is ever
damaged, replace it immediately.
• Never put your hands or feet under the mower.
• Never try to clear the discharge area or mower
blades unless you move the blade-control switch
(PTO) to the O
key to the O
• Make sure that the grass deflector is in the down
position.
28
Installing the Mower Deck
position, rotate the ignition
FF
position, and remove the key.
FF