Operating The Blade-Control Switch (Pto); Driving The Machine - Toro TITAN ZX 4800 Operator's Manual

A
C 00:60 Sec
E
Figure 16
Operating the Blade-Control
Switch (PTO)
The blade-control switch (PTO) starts and stops the mower
blades and any powered attachments.
Engaging the Blade-Control Switch
(PTO)
Engage the blade-control switch (PTO) with the throttle
position at F .
AST
Note: Engaging the blade-control switch (PTO) with the
throttle position at half or less will cause excessive wear to
the drive belts.
Figure 17
B
D
g027641
G008945
Disengaging the Blade-Control Switch
(PTO)

Driving the Machine

The throttle control regulates the engine speed as measured
in rpm (revolutions per minute). Place the throttle control in
the F position for best performance. Always operate in
AST
the full-throttle position when mowing.
CAUTION
Machine can spin very rapidly. Operator may lose
control of machine and cause personal injury or
damage to machine.
• Use caution when making turns.
• Slow the machine down before making sharp
turns.
Using the Motion-Control Levers
Use the motion-control levers as shown in
21
G009174
Figure 18
Figure 19.