Servicing The Fuses - Toro TITAN ZX 4800 Operator's Manual

1. Charge battery for 10 to 15 minutes at 25 to 30 amps
or 30 minutes at 10 amps.
2. When the battery is fully charged, unplug the charger
from the electrical outlet, then disconnect the charger
leads from the battery posts
3. Install the battery in the machine and connect the
battery cables.
1. Positive battery post
2. Negative battery post

Servicing the Fuses

The electrical system is protected by fuses. It requires
no maintenance; however, if a fuse blows, check the
component/circuit for a malfunction or short.
Note: The fuses are located on right hand console next to
the seat (Figure 54).
Fuse type:
•
Main—30 A, blade-type
•
Engine—20 A, blade-type
1. To replace the main fuse, grasp the fuse and pull it
straight and away from the fuse block
(Figure 53).
Figure 53
3. Red (+) charger lead
4. Black (-) charger lead
(Figure
1. Fuse block
Important: Ensure that the new fuses are the
same type and amperage as the fuses removed.
2. To replace the engine fuse, remove the console from
the plastic fender.
54).
1. Engine fuse—25 A
3. Grasp the engine fuse and pull it straight and away
from the fuse block
4. Align a new fuse with the slot in the fuse block
54).
5. Push the fuse into the fuse block until the fuse is seated
(Figure
40
2
1
Figure 54
2. Main—30 A
Figure 55
(Figure 55).
54).
g02441 1
(Figure