Installing The Mower Deck; Replacing The Grass Deflector - Toro TITAN ZX 4800 Operator's Manual

Removing the Mower Deck
1. Remove the hairpin cotter and washer securing the
link pin to the frame and deck, and remove the link
bar (Figure 74).
Figure 74
1. Link pin
2. Washer
2. Lift up the mower deck to relieve tension from the
mower deck.
3. Remove the chains from the hooks on the deck-lift
arms (Figure 75).
Figure 75
1. Deck-lift arm
2. Chain
4. Raise the height of cut to the transport position.
5. Remove the belt from the clutch pulley on the engine.
6. Slide the mower out from underneath the machine.
Note: Retain all parts for future installation.
3. Hairpin cotter
3. Hook
4. Adjustment bolt

Installing the Mower Deck

1. Park the machine on a level surface and disengage the
blade-control switch.
2. Move the motion-control levers outward to the
N -L
EUTRAL OCK
the key, set the parking brake, and wait for all moving
parts to stop before leaving the operating position.
3. Slide the mower under the machine.
4. Lower the height-of-cut lever to the lowest position.
5. Place the height-of-cut pin in the lock position for
lowest height of cut.
6. Lift the rear of the mower deck and attach the chains
to the rear lift arms
7. Attach the front chains to the front lift arms
75).
8. Install the long link bar through the frame hanger and
deck.
9. Secure the link pin with the hairpin cotters and washers
removed previously
10. Install the mower belt onto the engine pulley; refer to
Replacing the Mower Belt (page
11. Tighten the 2 bottom bolts holding the mower-deck
curtain to the mower deck; refer to
Mower-Deck Curtain (page

Replacing the Grass Deflector

Service Interval: Before each use or daily—Inspect the grass
deflector for damage.
WARNING
An uncovered discharge opening could allow the
lawn mower to throw objects in the operator's or
bystander's direction and result in serious injury.
Also, contact with the blade could occur.
Never operate the lawn mower unless you install a
mulch plate, discharge deflector, or grass collection
system.
Inspect the grass deflector for damage before each use.
Replace any damaged parts before use.
1. Remove the cotter pin from the end of the rod
76).
2. Disengage the spring from the notch in the deflector
bracket and slide the rod out of the welded deck
brackets, spring, and discharge deflector
Note: Remove the damaged or worn discharge
deflector.
49
position, shut off the engine, remove
(Figure 75).
(Figure 74).
48).
Releasing the
33).
(Figure
(Figure
(Figure
76).