Hitachi C 10FL Instruction Manual And Safety Instructions page 18

English
RIP FENCE INDICATOR (FIG. T)
NOTE: The rip fence indicator points to the scale on
the front of the table saw. Measurement shown by
the indicator will provide the user with accuracy up
to 1/16 of an inch. Measurement shown is the
distance from the blade to the side of the fence
closest to the blade.
1. To check the accuracy, measure the actual distance
to the side of the rip fence. If there is a difference
between the measurement and the indicator, adjust
the indicator as shown next.
2. Loosen the indicator screws (1). Slide the indicator to
the correct measurement position on the scale, then
retighten the indicator screws (1).
Fig. T
1
2
RIP FENCE OPERATION (FIG. T)
The rip fence moves to either side of saw blade. The
right side is the most common position. Front and rear
guide the fence. Calibrations on the front guide rail
show distance between fence and saw blade.
To adjust rip fence, raise clamp lever to maximun
height, push fence desired distance from saw blade,
and turning micro-set knob (2) left or right.
– 18 –