Hitachi C 10FL Instruction Manual And Safety Instructions page 17

Power Cord (Fig. P)
For convenience and to prevent damage to the power
cord when the table saw is not in use or is being
transported, the frame of leg has two brackets (1) on
the side for cord atorage.
Fig. P
1
MITRE GAUGE ADJUSTMENT (FIG. Q)
1. Make sure that the mitre gauge bar (1) will slide
freely through the table top grooves.
2. Loosen the lock knob handle (2) and turn the gauge
body (3) to set the pointer (4) at 0 on the scale.
3. Make a 90º cut in a scrap piece of wood. Check
the cut to see if it is 90º. If not, loosen the lock knob
handle (2) and move the mitre gauge body until it is
square to the miter gauge bar by using a combination
square.
MITRE GAUGE OPERATION (FIG. Q)
The mitre gage is accurately construted with index
stops at 0º, 15º, 30º, 45º, 60º both right and left side.
The operate the mitre gage, simply loosen the lock
handle (2) and move the body of the mitre gauge to the
desired angle. The mitre gauge body will stop at 0º, 15º,
30º, 45º, 60º both right and left side.
Fig. Q
3
2
1
– 17 –
RIP FENCE ADJUSTMENT (FIG. R, S)
1. For adjustments, position the fence to the right of the
blade, parallel with the miter gauge groove.
2. Place the rear clamp (1) of the fence on the back rail
of the table, and lower the front end over the front rail
(2). Push the handle (3) down to lock.
3. To change the position of the fence, lift up on the
handle to unlock, and slide the fence to the desired
position, then push the handle down to lock.
Fig. R
2
If the fence is loose when the handle is in the locked
position: (Fig. S)
1. Move the handle upward to the unlocked position.
Turn the adjusting screw (4) clockwise until the rear
clamp is snug.
2. DO NOT turn the adjusting screw more than 1/4 turn
at a time.
3. Over-tightening the screw will cause the rip fence to
come out of alignment.
WARNING
Failure to properly align the fence can cause "kickback"
and serious injury could occur.
Fig. S
4
English
3
1