Table of Contents
Advertisement
This Manual: http://www.manuallib.com/file/2538033
Clear CMOS Jumper: JP1
The "Clear CMOS" jumper is used when you cannot boot your system due to some CMOS
configuration such as a password that is forgotten. This jumper allows you to reset the CMOS
configurations, and then reconfigure.
Pin1-2 short
Normal (default)
Pin2-3 short
Clear CMOS data
(Short means to cover two pins on
a jumper using a jumper cap.)
The following procedures are for resetting the BIOS password. It is
important to follow these instructions closely.
1. Turn off your system and disconnect the AC power cable.
2. Set JP1 pin 2-3 closed.
3. Wait several seconds.
4. Set JP1 pin 1-2 closed.
5. Connect the AC power cable and turn on your system.
6. If you need to reconfigure the BIOS configuration data, you can do so by accessing the BIOS
Setup Utility.
3
2
1
JP1
3
2
1
JP1
17
KX600S PRO/ KX600S
D IMM 1
D IMM 2
D IMM 3
Advertisement
Table of Contents
