Security Measures
Setting the Hard Disk Lock (enabling, disabling)
same as they were before the hard disk was removed.
It is possible to set the Hard Disk Lock even if [Password on boot] is set to [Disable], but we
recommend that [Password on boot] be set to [Enable] for security reasons.
(Note that this Hard Disk Lock does not guarantee complete protection of data.)
NOTE
In the default setting, [Hard Disk Lock] is set to [Disable].
You cannot set [Hard Disk Lock] without setting the Supervisor Password. Set the
Supervisor Password if you have not done so. (
The hard disk lock function only works with the internal hard disk. This function does
not work with the second hard disk or the external hard disk.
1
Run the Setup Utility. (
2
Using either
3
Using either
4
Select [Enable] or [Disable].
To enable the Hard Disk Lock
Select [Enable] and press Enter. At [Caution], press Enter.
To disable the Hard Disk Lock
Select [Disable] and press Enter.
5
F10
Press
and select [Yes], then press
CAUTION
To change your hard disk drive
• Contact Panasonic Technical Support.
• Before changing the hard disk, be sure to set the [Hard Disk Lock] to [Disable].
page
76)
or , select [Security].
or
, select [Hard Disk Lock] and press
29
page
26)
Enter
Enter
.
.