Panasonic CF-73 Series Reference Manual page 69

LAN
3
Select [Power Management], add the check mark for [Allow this device to bring
the computer out of standby.] and [Allow the computer to turn off this device to
save power.], then select [OK].
CAUTION
Be sure to connect the AC adaptor, and enable the supply of power.
NOTE
Even when a password is set in the Setup Utility and [Password on boot] is set to
[Enable], it is not necessary to input the password set in the Setup Utility when the
computer resumes from standby or hibernation mode.
The Wake up from LAN function will not operate under the following conditions:
• When the computer has been shut down.
• When the power switch is pressed over for four seconds or longer to turn off the
power (e.g., when the computer hangs).
• When the AC adaptor and battery pack are removed from the computer or
reattached to the computer.
After operations are resumed from standby mode, the screen remains dark. The
former screen display will be restored when the keyboard, touch pad or touchscreen
(only for models with touchscreen) is touched.
The computer may start up if accessed by another computer on the network.
Windows XP
The following procedure can be used to prevent startup due to unintentional access
by a computer.
1
Select [Start] - [Control Panel] - [Performance and Maintenance] - [System] -
[Hardware] - [Device Manager] - [Network adapters], then select the internal
network adaptor, and then select [Power Management].
2
Add the check mark for [Only allow management stations to bring the computer
out of standby], then select [OK].
69