Table of Contents
Advertisement
Charging the built-in battery/Setting the time code
Recharging the built-in battery
The camera's internal battery saves the date and
time.
When SET DATE AND TIME is displayed even
when the date and time are set, it means that the
charge of the internal battery is depleted. Do the
following to recharge it.
Reset the date and time when fully recharged.
1
Connect the AC adapter. (Page 23)
•
Leave the POWER switch at OFF.
2
Leave the camera-recorder like this for
about 4 hours.
•
The internal battery charges during this time.
•
Check the time code and menu operations
after recharging.
If the date and time are not memorized after
recharging, the internal battery requires changing.
Please consult the place of purchase.
Setting the time code
In the setup menus, RECORD SETUP screen, set
the following time code related items. (Page 102)
•
TCG
•
TC PRESET
AG-HMC41E(VQT2H31(E))̲E.indb 59
AG-HMC41E(VQT2H31(E))̲E.indb 59
Specifying the time code
Set TC PRESET so you can record a value of
your choice as the initial setting for the time code
to be used at the start of recording.
1
Set the POWER switch to ON. (Page 26)
2
Touch the TC PRESET item in the setting
menu RECORD SETUP screen.
•
Menu operation (Page 95)
•
Operations may also be performed
using buttons on the remote control that
correspond to those on the camera. For
details, see "Description of parts (Remote
control)". (Page 20)
3
Touch YES.
4
Touch the item you want to set, and touch
or
to set the value.
You can reset the time code to zero by pressing
RESET button.
Camera
(Continued on the next page)
59
2009/07/11 18:41:12
2009/07/11 18:41:12
Advertisement
Table of Contents
