Installing The I/O Board; Driving Board; Removing The Driving Board - Dell Latitude 14 Rugged - 5414 Owner's Manual

Installing the I/O board

1. Place the I/O board on the computer.
2. Tighten the screws to secure the I/O board to the computer.
3. Connect the display assembly cable to the computer.
4. Connect the I/O cable to the computer.
5. Tighten the screw to secures the I/O board.
6. Slide the I/O board into its place on the computer.
7. Close the I/O bay press latch door.
8. Install:
a. base cover
b. optical drive
c. hard drive
d. battery
9. Follow the procedure in

Driving board

Removing the driving board

1. Follow the procedure in
2. Remove the:
a. battery
b. hard drive
c. optical drive
d. base cover
3. To remove the driving board:
a. Peel the adhesive tape to access the display assembly cable [1].
b. Disconnect the display assembly cable [2].
c. Peel the adhesive tape to access the I/O cable [3].
d. Disconnect the I/O cable [4].
e. Remove the screws that secure the driving board to the computer [5].
f. Lift the driving board from the computer [6].
42
After working inside your
Before working inside your
computer.
computer.