28
www.electrolux.com
7.2 Adjustment of the remaining
laundry moisture degree
To change the default degree of the
remaining moisture of the laundry:
1. Use the programme knob to set any
programme.
2. Wait approximately 8 seconds.
3. Press and hold buttons (A) and (B) at
the same time.
One of the these indicators comes on:
8. BEFORE FIRST USE
Before you use the appliance for the first
time do these operations:
• Clean the tumble dryer drum with a
moist cloth.
9. DAILY USE
9.1 Start a programme without
delay start
1. Prepare the laundry and load the
appliance.
2. Set the correct programme and
options for the type of load.
The display shows the programme
duration.
3. Press the Start/Pause touchpad.
The programme starts.
9.2 Starting the programme with
delay start
1. Set the correct programme and
options for the type of load.
2. Press the delay start button again and
again until the display shows the delay
time you want to set.
CAUTION!
Make sure that when you
close the door, the
laundry does not catch
between the appliance
door and the rubber seal.
•
the maximum dry laundry
•
the more dry laundry
•
the standard dry laundry
4. Press the button (E) again and again
until the indicator of the correct level
comes on.
5. To confirm the adjustment, press and
hold buttons (A) and (B) at the same
time for approximately 2 seconds.
• Start a short programme (e.g. 30
minutes) with moist laundry.
You can delay the start of
a programme from a
minimum of 30 minutes
to a maximum of 20
hours.
3. Press the Start/Pause touchpad.
The display shows the countdown of the
delay start.
When the countdown is completed, the
programme starts.
9.3 Change a programme
1. Turn the Programme knob to
2. Set the programme.
9.4 At the end of the programme
When the programme is completed:
• An intermittent acoustic signal
operates.
• The indicator
• The indicator
• The Start/Pause indicator is on.
The appliance continues to operate with
the crease guard phase for approximately
other 30 minutes.
The crease guard phase removes creases
from your laundry.
OFF
flashes.
comes on.