Attaching The Cable Clamp Belt (Supplied) - Sony super motion hdc4300 Operation Manual

4
Adjust the front-rear position so that the camera
handle does not interfere when you rotate the
BKW-401 arm upwards.
Not interfering with handle
Attaching the Cable Clamp Belt
(Supplied)
You can secure the optical/electrical multi cable, connected to
the BPU connector, to the side of the camera by attaching the
supplied cable clamp belt.
1
Insert the belt bracket into hole
clamp belt.
Belt bracket
2
Remove two +B3×5 screws and a hidden screw
shown in the figure below from the camera.
Hidden screw
Screws (+B3×5)
D
or of the cable
A B
B
A
3
Secure the cable clamp belt to the camera, using the
two supplied +B3×8 screws.
Screws (+B3×8)
4
Release the buckle,
1
belt, then lock the buckle again.
3
1
Optical/electrical
multi cable
5
Adjust the length by pulling down the end of the belt.
16
bundle the cable with the
2
3
2