Sony super motion hdc4300 Operation Manual page 15

3
Tighten the viewfinder left-right positioning ring.
To adjust the position forward or backward
LOCK knob
1
Loosen the viewfinder front-rear positioning lever
and LOCK knob.
2
Slide the viewfinder towards the front or rear of the
camera to move it into a good viewing position.
3
Tighten the viewfinder front-rear positioning lever
and LOCK knob.
Detaching the viewfinder
Loosen the viewfinder left-right positioning ring, pull the
viewfinder stopper, then pull out the viewfinder by sliding it in
the direction opposite to that when attached.
Keeping the viewfinder from hitting your leg
(using BKW-401)
To keep the viewfinder from bumping your leg when carrying
the camera, install the BKW-401 Viewfinder Rotation Bracket
(optional) and rotate the viewfinder upwards.
Note
Lock the viewfinder in a slightly forward position before
rotating it upwards. If the viewfinder is in its rearmost position,
the arm of the viewfinder rotation bracket will strike the camera
handle.
Viewfinder front-rear
positioning lever
Attaching procedure of the BKW-401
1
Turn the arm of the rotation mechanism assembly of
the BKW-401 in the direction of the arrow in the
following illustration.
Next, using a hexagonal wrench 3 mm across flats,
remove the bolts (M4×8) together with the washers, to
separate the rotation mechanism assembly from the
viewfinder front-back positioning mechanism
assembly.
2
In the same manner as step 1, remove the viewfinder
shoe of the camera from the front-rear positioning
mechanism assembly.
D
3
Using the two bolts (M4×8) and the washers removed
from the camera in step 2, attach the rotation
mechanism assembly of the BKW-401 to the camera.
15
Bolt
M4×8
D