Accessories - Teknatool NOVA 3000 Instruction Manual

Accessories

Add On Bed Extension
Extend the bed of your Nova 3000 Woodlathe
for greater capacity for turning between
centers. Each bed unit adds 510 mm (20 in.)
Lathe Stand
Strong, rigid, 4 mm thick sheet metal lathe
stand, 86 cm (34 in.) high for the Nova 3000.
The legs have an extra flange to allow you to
insert a piece of plywood to create a boxed leg
for filling with sand for even extra vibration
dampening. The stand is available in two
models one to fit the standard Nova 3000 and
one to fit an additional add-on extension bed.
SuperNova Chuck
A next-generation, self-centering chuck to
securely hold round and square work pieces
for centerless turning. The special Tuff Lock
gearing delivers amazing holding power in both
the contraction and expansion mode. It has an
open-back for easy cleaning and can be
tightened one-handed with an articulated key.
It includes a screw chuck. A wide variety of
optional jaws are available to hold almost any
work piece.
Small Toolrest
A small 100 mm (4 in.) toolrest (not shown) for
turning small work pieces or reaching into
recessed areas.
Bowl Toolrest
A curved toolrest which gives you better chisel
support on both the outside and inside of a
bowl. Because of the curve you are able to
position your chisel support closer to the bowl.
Revolving Center System
A multi-function live center system to expand
your options when turning between centers. It
includes quick change tapers: a hollow cup
center point, threaded center, cone center, and
an extension center. Made with three bearings
and precision machined for a high quality
finish.
Handwheel Unit
The handwheel is mounted on the outboard
end of the headstock spindle so you can
manually position work or to slow it down. The
vacuum coupler can also be added to this unit
to make a vacuum holding option.
Lathe Stand
Revolving
Center
System
Add-on
Bed Extension
SuperNova
Chuck
Handwheel
Unit