Nova 3000 Specifications - Teknatool NOVA 3000 Instruction Manual

Nova 3000 Woodlathe Specifications
Size: see drawing below.
Weight: 66 kg (145 lb) (without motor)
Swing Over Bed: 400 mm (16 in.)
Distance Between Centers: 600 mm (24 in.);
expandable in 510 mm (20 in.) units with
add-on Bed sections.
Swing Outboard: 740 mm (29 in.) with headstock
at 90° with outrigger toolrest.
Headstock:
Spindle Thread: M30 x 3.5 RH
(2)
1-1/4 x 8 TPI RH
(3)
M33 x 3.5 RH
Headstock Bore: No. 2 Morse Taper (#2 MT)
Headstock Swivel: 0 to 360 degrees, with
detents at 0, 22.5, 45, and 90 degrees.
Outboard End Internal Thread: M20 x 1.5 LH
Spindle Index: 24 divisions (every 15 degrees)
Tailstock:
Tailstock Bore: No. 2 Morse Taper (#2 MT)
Quill Travel: 85 mm (3-1/4 in.)
Hole Through Tailstock: 15 mm (9/16 in.)
Toolrest:
Length: 300 mm (12 in.)
Shaft Diameter: 25.4 mm (1 in.)
Motor Options (Recommended):
AC Motor, 1 HP, 1425 rpm, 50 Hz
AC Motor, 1 HP, 1725 rpm, 60 Hz
America, the 1 HP AC motor is included with the
lathe.
DC Motor, 1 HP, 0-1750 rpm, 50-60 Hz
Speeds (rpm): 8-step motor pulley
178, 300, 570, 850, 1200, 1800, 2400, 3000
215, 360, 690, 1030, 1450, 2180, 2900, 3630
8
Standard Equipment:
300 mm (12 in.) Toolrest, Poly Vee Drive Belt,
Motor Pulley, Motor Mounting Kit, 150 mm (6 in.)
Faceplate (Not all countries, see notes below), 1
HP AC Motor (Not all countries, see notes below)
Spur Center, and Live Center
Nova 3000 Bowl Lathe Version:
Specifically for bowl turning, does not include bed
extension, tailstock, and centers.
Optional Accessories:
(1)
or
Foot Mounting Rail Kit
Nova Chuck System
SuperNova Chuck System
Faceplates: 80 mm (3 in.), 150 mm (6 in.)
Vacuum Faceplate
Toolrest: 100 mm (4 in.)
Bowl Toolrest
Outrigger Toolrest Unit
Handwheel
Vacuum Coupler
Revolving Center System
Ornamental Turner
Hiturn Sharpening Center
Notes:
(1) Applicable to New Zealand, Australia, and South
(2) Applicable to United States, Canada, and UK.
(1)
(3) Applicable to Europe
(2)
In North
country. In the USA, the 150mm (6") faceplate and 1 HP
(2)
AC Motor are included with the lathe as standard
equipment. In other markets, the motor and the faceplate
are optional equipment. Check with your reseller if you are
(1)
unsure.
(2)
Africa.
Note: Standard equipment varies from country to
92-0106-017