Teknatool NOVA 3000 Instruction Manual page 13

Teebar
Motor Mount Cam
Nyloc Nut
12. Fit the belt over both pulleys. Adjust the position of the motor pulley on the motor shaft so the belt is
aligned square between the pulleys. Tighten the M8 set screw on the motor pulley.
Note: The drive belts correct positioning is with the belt overhanging the outside of the pulley by one
rib. It is only on the bottom (smallest step) that all six ribs are used.
13. Push the Teebar away from the lathe to increase the belt tension. Tighten the Teebar to lock the
motor in place. Close the guard lid and secure the lid with the screw knob.
14. Assemble the handles:
Note: Some handles may come
pre-assembled.
Toolrest Clamp Handle -
insert the rod through the handle
and screw the ball knobs onto
each end of the rod.
Toolslide Clamp Handle - screw
the rod into the toolslide.
Tailstock Clamp Handle -
screw the rod into the tailstock.
92-0106-017
Installing the Motor and Guard
Motor
Pulley
Headstock
Studs
Motor
Mount Plate
Headstock Guard
Screws (5)
Screw Knob
Belt
Headstock
13