Mounting The Lathe To A Support Surface; Connecting To Power - Teknatool NOVA 3000 Instruction Manual

Mounting the Lathe to a Support Surface

Maximum of 25 mm (1 in.)
(Required only for mounting the
Outrigger Unit option.)
1. Place the lathe on the stand top. Locate the front and left corner of the lathe approximately 25 mm (1
in.) from the corner edge of the stand top. This provides a comfortable reach when turning and
allows the optional outrigger unit to be easily installed.
2. If necessary, mark the six hole locations on the top and drill M12 (1/2-inch) holes.
3. Place a spirit level along the top of the lathe bed. Any movement of the bubble as the lathe is
secured, indicates a twist on the bed. For the lathe to operate correctly the bed must not twist; if
necessary, use shims between the bed and stand top.
4. Use bolts of suitable length (not included) to secure the lathe. Tighten the two headstock bolts first,
then the two tailstock bolts, and finally tighten the two middle bolts.
5. The two 12mm threaded holes underneath the outrigger end of headstock can be optionally used
(making a total of 8 bolt positions) ensure that the bolt is a metric M12 x 1.75 mm pitch and that the
length is correct to ensure that the bolt doesn't bottom in the threaded hole and potentially damage
casting.

Connecting to Power

Follow any instructions that came with the electric motor and switch. The motor should be wired so it
rotates in a counter-clockwise direction (when facing the output shaft of the motor). A properly rated on/off
switch should be used. DC motor electronic controls may require adjustment for correct operation.
The power cord should be 3-wire, having a grounding conductor and a grounding plug. The plug must be
plugged into a matching outlet that is properly installed and grounded in accordance with local electrical
codes.
!
Warning!
Improper connection of the motor can result in a risk of electrical shock.
If it is necessary to use an extension cord, the cord should be grounded. Use the proper wire size for the
extension cord, for a given cord length, to avoid power loss and over-heating.
92-0106-017
Bolt tightening sequence
1st
Recommended Extension Cord Size for 1 HP Motor
Cord Length
0-25 ft (0-7.5 m)
26-50 ft (8-15 m)
51-100 ft (16-30 m)
3r d
Mounting Holes (6)
!
The lathe must be fastened to a
support surface, such as a lathe
stand or bench.
Wire Size (American Wire Gauge)
16 AWG
14 AWG
12 AWG
2nd
15