Relay - Fronius Galvo 208-240 1.5-1 Operating Instructions Manual

IMPORTANT! The time must be set correctly in order for the logging function to work prop-
erly.

Relay

Activate Relay, Relay Settings, Relay Test
Setting range
* only shown if the 'E-manager' function has been activated under "Relay Mode."
Relay Mode
For selection of the various functions of the potential-free switching contact in the data
communications area:
-
-
-
Setting range
Factory setting
Relay test
Functional test to check if the potential-free switching contact works
Switch on point (only if "Energy manager" function is activated )
for setting the effective power limit from which the potential-free switching contact will be
switched on
Factory setting
Setting range
Switch off point (only if the "Energy manager" function is activated)
for setting the effective power limit from which the potential-free switching contact will be
switched off
Factory setting
Setting range
Relay Mode / Relay Test / Switch on Point* / Switch off Point*
Alarm function
Active output
Energy manager
ALL / Permanent / OFF / ON / E-manager
ALL
Alarm function:
Permanent / Switches the potential-free switching contacts for continual and tem-
ALL: porary service codes (e.g., brief interruption of grid power feed opera-
tion, a service code occurs a set number of times per day – can be set
in the "BASIC" menu)
Active output:
ON: The potential-free switching contact NO is switched on at all times
while the inverter is operating (as long as the display lights up or ap-
pears)
OFF: The potential-free switching contact NO is switched off
Energy manager:
E-manager: You can find additional information on the "Energy manager" function
in the "Energy Manager" section below
1000 W
Switch off point – max. power rating of the inverter / W / kW
500
0 – switch on point / W / kW
27