Connection Diagram - 4 Relay - Fronius Primo GEN24 3.6 Operating Instructions Manual

Control priorities
For setting the control priorities for the ripple control signal receiver, the feed-in
limitation and control via Modbus.
1 = highest priority, 3 = lowest priority
Connection dia-
The ripple control signal receiver and the I/Os terminal of the inverter can be
gram - 4 relay connected to one another in accordance with the connection diagram.
If the distance between the inverter and the ripple control signal receiver ex-
ceeds 10 m, at least a CAT 5 cable is recommended and the shield must be con-
nected at one end to the push-in terminal of the data communication area
(SHIELD).
(1)
(2)
Use the preconfigured file for 4-relay mode:
1
2
3
The settings for 4-relay mode are stored.
130
(1)
100 %
60 %
30 %
0 %
Ripple control signal receiver with 4 relays, for effective power limiting.
I/Os of the data communication area.
Download the file (.fpc)
Upload the file (.fpc) in the
port" button.
Click on the "Save" button.
V+
IN8
IN9
IN10
IN11
under 4-relay mode onto the end device.
"I/O Power Management"
(2)
menu using the "Im-