Maintenance - Dimplex SP16 Manual

Operation of the Wall Fire.
Manual Operation
The switches are located at the bottom right side of the
appliance - see Fig. 8.
S1 - Power Switch.
S2 - Fire Operation Mode.
S3 - Downlight On/Off.
Remote Operation
The standby switch (S1) must first be turned 'ON'.
Note: It takes some time for the receiver to respond to the
transmitter. DO NOT PRESS the buttons more than once within
two seconds for correct operation.
Manual & Remote Operation
The standby switch (S1) must first be turned 'ON' to operate
the appliance manually or by remote control
Switch 2 (S2) of the appliance or the "I" button on the remote
control operate the fire as follows:
Setting Operation
(Remote or S2 switch)
Flame Effect Press the 'I' button once
Flame Effect & 1kw Heat Press the 'I' button twice
Flame Effect & 2kw Heat Press the 'I' button three times.
When using the S2 switch press the "O" side of the button
goes to the previous settings.
Pressing the "O" button on the remote control turns the
appliance off. To turn the appliance On press the "I"
button.
The unit is supplied with a Top Light to illuminate the fuel bed.
This feature can be turned ON or OFF depending on your
preference. Switch 3 allows you to control this light.
To turn off the power the power switch S1 must be turned 'OFF'.

Maintenance

WARNING – BEFORE UNDERTAKING ANY MAINTENANCE
OR CLEANING, REMOVE PLUG OR DISCONNECT FROM
THE ELECTRICITY SUPPLY.
Light Emitting Diode
This fire is fitted with LED (Light Emitting Diode) lamps. These
LED lamps are maintenance-free and should not require
replacing during the life of the product.
Thermal Safety Cut-out
For your safety, this appliance has been fitted with thermal
cut-outs. In the event that the product overheats, the cut-out
switches the heat off automatically.
To bring the heat back into operation, remove the cause of the
overheating, then unplug or turn off the electrical supply to the
heater for up to 10 minutes.
When the heater has cooled sufficiently, re-connect and switch
on the heater.
Cleaning
WARNING – ALWAYS DISCONNECT FROM THE POWER
SUPPLY BEFORE CLEANING THE APPLIANCE.
For general cleaning use a soft clean duster – never use
abrasive cleaners. The glass viewing screen should be
cleaned carefully with a soft cloth. DO NOT use proprietary
glass cleaners.
Recycling
For electrical products sold within the European
Community.
Confirmation Light
At the end of the electrical products useful life it
(Fig. 9)
should not be disposed of with household waste.
Please recycle where facilities exist. Check with
Top Neon
your Local Authority or retailer for recycling advice in your
Middle Neon
country.
Bottom Neon
After Sales Service
Your product is guaranteed for one year from the date of
purchase.
Within this period, we undertake to repair or exchange this
product free of charge (subject to availability) provided it
has been installed and operated in accordance with these
instructions.
Your rights under this guarantee are additional to your statutory
rights, which in turn are not affected by this guarantee.
Should you require after sales information or assistance with
this product please go to www.dimplex.co.uk where you will
find our self help guide by clicking on "After Sales" or ring our
helpdesk on 0844 879 3588 (UK) or 01 842 4833 (R.O.I.) .
Spare parts are also available on the website :
Please retain your receipt as proof of purchase.
www.dimplex.co.uk