Servo-Conection; Power-Connection - GRAUPNER GR-12L HoTT Manual

3.1. SERVO-CONECTION

Plug the servos into the connector of the receiver. The socket is also polarized, pay attention to the small lateral bevels.
Contact should easily snap on no account force to the plug. The sockets are labeled accordingly, the brown wire (-), red (+)
and orange (signal). The servo connections of Graupner HoTT 2.4 GHz receiver are numbered.
The channel 6 port can be programmed for the (digital) signal output.

3.2. POWER-CONNECTION

No specifi c jacks are provided for connecting the battery. Connect the power supply to the preferred / the socket (s) that
are close to the servos. If you want to connect several separate batteries, make sure that the batteries have the same rated
voltage and rated capacity. Not include different types of batteries or batteries with different charge levels too greatly,
since this may lead to short-circuit-like effects. Turn in such cases for safety voltage stabilizers such as PRX-5A receiver
power supplies.
(Order No. 4136) between battery and receiver.
receiver socket: Graupner/SJ(JR) Typ female 3 Pins
CHANNEL
1
2
3
4
5
6
FUNKTION
signal output
signal output
signal output
signal output
signal output
signal output
ALTERNATIV
-
-
-
-
Telemetrie, Firmware update
SUMD output
15