Cabinet Installation - Panasonic CW-XC145HU Installation And Operating Instructions Manual

Cabinet Installation

1. Open the window. Mark a line on the center
of the window stool between the side
window stop moldings.
Loosely attach the sill bracket to the support
bracket using the carriage bolt and the lock
nut. (See Fig. 5)
2. Attach the sill bracket to the window sill
using the screws (Type B).
Carefully place the cabinet on the window
stool and align the center mark on the
bottom front with the center line marked
window stool.(See Fig. 6)
3. Using the M-screw and the lock nut, attach
the support bracket to the cabinet track hole.
Use the first track hole after the sill bracket
on the outer edge of the window sill. Tighten
the carriage bolt and the lock nut. Be sure
the cabinet slants outward. (See Fig. 6)
CAUTION: DO NOT DRILL A HOLE IN THE
BOTTOM PAN.
The unit is designed to operate
with approximately 12.7 mm
(1/2") of water in bottom pan.
4. Pull the bottom window sash down behind
the Top retainer bar until they meet.(See
Fig. 7)
NOTE: 1. Do not pull the window sash down so
tightly that the movement of Frame
curtain is restricted. Attach the
cabinet to the window stool by
driving the screws (Type B) through
the cabinet into window stool. (See
Fig. 8)
2. The cabinet should be installed with
a very slight tilt downward toward the
outside.
Sill
Bracket
Carriage
Bolt
(Type M)
Cabinet
Track hole
Support
Bracket
Carriage bolt
and lock nut
13
Support
Bracket
Lock nut
Fig. 5
Machine screw (Type D)
and lock nut
Outer edge
of window
sill
Screw (Type B)
Sill bracket
Fig. 6
Fig. 7
Fig. 8