hsr-benelli S SERIES User Manual page 52

Hide thumbs Also See for S SERIES:
Table of Contents

Advertisement

The PWC must be levelled and the engine cold in order to perform the oil level verification. Check
the oil level by pulling up the oil dip stick out of the engine. The oil level must be within the minimum
and maximum marks. Follow the same procedure when the engine is warm, but make sure your
check is done five minutes after the engine stopped to allow the remaining oil to go back to the
bottom of the engine. The oil level may be higher than with a cold engine, since the oil volume
increases when it's warm. The oil may be hot.
Never let the engine run out of the water without cooling.
Caution
Never allow the oil level to exceed the Overfill mark. This could cause a major engine damage.
2
HSR-BENELLI SERIES-S Manual | EN -

Advertisement

Table of Contents
loading

Related Products for hsr-benelli S SERIES

Table of Contents