Yamaha WR450F Owner's Service Manual page 203

2. Tighten:
• Damper assembly "1"
Damper assembly
30 Nm (3.0 m·kgf, 22 ft·lbf)
TIP
Use the cap bolt ring wrench "2" to tighten the
damper assembly.
Cap bolt ring wrench
90890-01501
Cap bolt ring wrench
YM-01501
1
3. Adjust:
• Front fork top end "a"
Front fork top end (standard) "a"
5 mm (0.20 in)
a
4. Tighten:
• Pinch bolt (upper bracket) "1"
• Pinch bolt (lower bracket) "2"
EWA
Tighten the lower bracket to specified
torque. If torqued too much, it may cause
the front fork to malfunction.
5. Install:
• Speed sensor lead "1"
• Plate 1 "2"
2
TIP
Install the speed sensor lead so that its paint "a"
directs as shown and align the bottom "b" of the
plate 1 with the same paint.
5-51
Upper bracket pinch bolts
21 Nm (2.1 m·kgf, 15 ft·lbf)
Lower bracket pinch bolts
21 Nm (2.1 m·kgf, 15 ft·lbf)
WARNING
1
2
(to the right front fork protector)
Plate 1 bolt
3.8 Nm (0.38 m·kgf, 2.8 ft·lbf)
2
1
FRONT FORK
b
a