Yamaha WR450F Owner's Service Manual page 190

WARNING
After tightening the throttle cable housing
screws, check that the throttle grip "3"
moves smoothly. If it does not, retighten the
screws for adjustment.
10.Install:
• Rubber cover "1"
• Cover (throttle cable housings) "2"
11.Install:
• Start switch "1"
• Front brake master cylinder assembly "2"
• Front brake master cylinder holder "3"
• Bolt (brake master cylinder holder) "4"
• Clamp "5"
Front brake master cylinder hold-
er bolt
9 Nm (0.9 m·kgf, 6.5 ft·lbf)
TIP
• Install the brake master cylinder holder with
the "UP" mark facing up.
• Install in order for the top of the front brake
master cylinder assembly to be level.
• First, tighten the upper bolt, then the lower
bolt.
3
2
5
12.Install:
• Clutch cable "1"
TIP
Before installation, apply the lithium-soap-
based grease to the clutch cable end.
13.Adjust:
• Clutch lever free play
Refer to "ADJUSTING THE CLUTCH LE-
VER FREE PLAY" on page 3-12.
Clutch lever free play
7.0–12.0 mm (0.28–0.47 in)
5-38
HANDLEBAR
4
1
4
LS
1