CDA CD 66 User Operating Instructions Manual page 8

Table of Contents

Advertisement

Electric Supply Requirements
WARNING!
This appliance must be earthed.
Your hob must be installed by a quali-
fied electrician in line with all electrical
and installation requirements published
by the Institute of Electrical Engineers.
To connect the feeder cable to the hob
it is necessary to carry out the following
operations:
Unscrew the shield "A" at the bottom
of the hob.
Position the straps "C" onto terminal
board "B" (fig. 6) according to the
diagram in fig. 7.
Insert the feeder cable of suitable sec-
tion (see below) through the hole of
the shield "A".
Connect the phase wires to terminal
board "B" according to the diagram in
fig. 7 and the earth wire to clamp "D".
Secure the feeder cable with cable
clamp "E".
Refit the shield "A".
D
E
IMPORTANT:
This appliance requires a 30 amp supply.
8
Figure 6
B
A
C
double pole switch must be provided
A
no further than 2 metres from the
appliance to the electrical supply.
All supply current and earth conductors
must be able to withstand an ambient
temperature of 75°C.
The appliance must be connected using
2
6 mm
cable (not supplied) in accordan-
ce with the following code:
GREEN or GREEN
AND YELLOW
BLACK or BLUE
RED or BROWN
As the colours of the wires in the cable
of this appliance (not supplied) may not
correspond
with
markings identifying the terminals in the
socket proceed as follows:
The wire which is coloured GREEN and
YELLOW must be connected to the
terminal which is marked with letter (E)
or by the Earth symbol
GREEN or GREEN and YELLOW.
The wire which is coloured BLUE must
be connected to the terminal which is
marked with the letter (N) or coloured
BLACK.
The wire which is coloured BROWN
must be connected to the terminal
which is marked with the letter (L) or
coloured RED.
NOTE: This appliance is intended to be
permanently connected to fixed wiring.
If you are using the hob for the first time,
or after a period of disuse, you should set
the controls to position 1 for approxima-
tely 30 seconds, to dry out any humidity.
Figure 7
1 2 3 4 5
L
Connection of cables inside the hob
= EARTH
= NEUTRAL
= LIVE
the
COLOURED
or coloured
PE
N

Advertisement

Table of Contents
loading

Table of Contents