Removable Oven Door; Replacingtheovenlight - Amana AGS780 Use And Care Manual

Hide thumbs Also See for AGS780:
Table of Contents

Advertisement

CARE AAID
Wash all surfaces frequently with
wipe the surfaces dry-after -washing.
Several different materials have been used in the construction of your range. Each material is well-suited to its
but care and cleaning of these materials differ. Some materials are harmed by cleaning agents that work well on others,
Materials to Use
Part
Glass Oven Door Front
Glass cleaner, e.g. Windex@
l
Soap and Water
l
Control Panel, Control
Soap and Water
l
Knobs and Controt
Buttons
Painted & Brushed
Soap and Water
l
Aluminum, Porcelain
Enamel, Staintess Steel
and Chrome
Storage Drawer
Soap and Water
l
Bake Burner and Broil
Burner
Broiler Pan and Grid
Soap and Water
l
Soap-Filled Scouring Pad
l
Oven Gasket
Oven Interior Surfaces*
Soap and Water
l
Oven Racks
Soap and Water
l
*IMPORTANT:
To prevent the possibility of stains, spills of marinades, fruit juices, vinegar, sour milk and basting materials containing acids which may cause
discoloration should be wiped up immediately. Use care not to touch any hot portion of the oven. When the surface is cool, clean and rinse. Acids can stain
even the most durable materials and finishes.

REMOVABLE OVEN DOOR

The oven door is removable for more convenience when
cleaning up large spills or cleaning the back of the oven. Do
not immerse the oven door in water when cleaning.
TO REMOVE OVEN DOOR:
Oven door is heavy.
door
1. Open
to first stop position (open approximately
4 inches).
2. Grasp the door firmly at each side and lift upward and off
the hinges.
TO REPLACE OVEN DOOR:
1. Align door with hinge arms.
2. Slide door down and into place. Be sure door is all the
way down on hinge before closing, to prevent the possi-
bility of chipping porcelain or scratching chrome.
soap and hot water to minimize
, _ _ .- . _
General Directions
Clean with glass cleaner or soap and water. Wipe with lintless cloth or towel. Be careful not to
spray cleaner inside vent openings.
Remove control knobs and control buttons by gently pulling them off. Wipe faces of control
knobs and buttons with cloth dampened in warm soapy water, rinse and dry well. To clean
control panel surface use a cloth dampened with warm soapy water, rinse and dry. Or spray
glass cleaner on a soft cloth and wipe control panel surface. Be careful not to allow liquids or
cleansers to run into openings. After replacing control buttons, press SET/CANCEL button
and cancel any accidentally entered programs.
Wash, rinse, dry with soft cloth.
Avoid abrasive cleansers which might scratch or dull the finishes.
Clean regularly when range has cooled.
Pull drawer out to open position and clean inside.
Do not clean the bake burner or broil burner.
Drain fat, cool pan and grid slightly. (Do not let soiled pan and grid stand in oven to cool.)
Sprinkle on detergent. Fill the pan with warm water. Let pan and grid stand for a few minutes.
Scour with non-abrasive pad if necessary Rinse and dry.
Avoid getting ANY cfeaning material on the gasket. Do not scrub woven gasket.
Cool before cleaning. Frequent wiping with mild soap and water will prolong the time between
major cleanings. Be sure to rinse thoroughly
For heavy soil, clean by hand and rinse thoroughly.
F
overall cleaning. To preserve the original appearance, rinse and
.
TO REPLACE OVEN LIGHT:
To avoid the risk of burns or electrical
shock:
Disconnect the electric current to the
l
appliance at the wall outlet fuse or
breaker box.
Wait until the oven light bulb is cool.
l
USE CAUTION WHEN REPLACING THE OVEN LIGHT.
1. Turn the glass cover counterclockwise to remove.
Remove the old bulb in the same manner. (A dry oven
mitt or cloth will protect against broken glass.)
2. Replace with a 40-watt appliance bulb, rotating it
clockwise.
3. Replace the glass cover by rotating it clockwise.
TOREPLACEBACKSPLASHFLUORESCENT
LIGHTBULB:
Flip up backsplash cover by firmly grasping with hands
l
and pulling upward.
Hold tube on both ends and rotate top toward back of
l
range. Lift out.
Slide tube pins located at each end
l
tube into lamp holder slots. Push down slightly and roll
toward you until it clicks into the socket. Close backsplash
top cover.
20
purpose,
specific
3
of replacement
bulb
. . .

Advertisement

Table of Contents
loading

Table of Contents