Table of Contents
Advertisement
detailed instructions on proper installation, refer to
For
the installation instructions included with the range.
You can install an optional vent hood ventilation system
above your range. Consult your Amana dealer for more
information about Amana vent hoods. Remember, it is
important to clean a vent hood frequently to prevent the risk
of fire.
To Avoid the Risk of Electrical Shock, I
Personal Injury, or Death:
Your range must be properly grounded and installed by
a qualified installer. It is the personal responsibility and
obligation of the customer to contact a qualified electri-
grounded circuit in accordance with the National. Elec-
tric Corde.
You can be assured, that your Amana range has been certi-
fied by the American Gas Association as being in compli-
ance with safety standards established by the American
National Standard Institute.
It is the responsibility of the installer to see that this
appliance is installed in accordance with the recommended
installation procedure.
A
CAUTION:
The range must be secured to the house structure. lnfor-
tion instructions and it is the responsibility of the installer
to see that this appliance is installed in accordance with
the recommended installation procedure. Anchoring is
required in order to prevent tipping while subjecting the
range to improper use.
Anti-tip brackets are included with your range. See instruc-
tions for complete details.
NOTE:
Slight smoking may occur when the oven is used for the first time. This is a normal condition.
WARNING:
Improper installation, alteration, service or m&ntonanC&
can cause injury property damage or death. Refei t6
manual. For assistance or additional information corisuit
a qualified installer, service agency, manufacturer (dealer)
or the gas supplier.
A gas pressure regulator is supplied and must be installed
when appliance is connected to gas supply.
The range is factory set for use with Natural Gas. If you wish
to use LR Gas, detailed instructions are provided in the
Installation Instructions. It is recommended by the manufac-
turer that the conversion be done by a qualified servicer.
TOP BURNER SETTINGS
Low burner flame may be adjusted by turning adjustment
screw in center of valve stem. Normally, the low flame
should be adjusted to the minimum steady blue flame.
(Approx. l/4" flame length.)
Check the adjustment by turning from high to low several
times to see that the burner does not go out.
REMOVAL AND REPLACEMENT OF RANGE
If the unit must be removed at any time after installation, the
following procedures must be followed:
1. Remove storage drawer (see page 21).
2. Shut off main gas supply valve to range.
3. Disconnect 12OV. supply plug.
4. Disconnect the range from the main gas supply connec-
tion above the shut off valve mentioned in Step 2. It is
essential that Step 2 has been carried out prior to dis-
connecting the supply from the range.
5. Your range is secured to the floor using (2) screws and
an anti-tip bracket.
6. Slide range forward. When re-installing the range, follow
the directions given in the Installation Instructions. See
page 9 for instructions on setting the electronic clock.
6
Advertisement
Table of Contents
