Technical Specifications - Omnitronic DXM-0808 Operating Instructions Manual

Procedure:
Step 1: Open the fuseholder on the rear panel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuseholder.
Step 3: Install the new fuse in the fuseholder.
Step 4: Replace the fuseholder in the housing.
Should you need any spare parts, please use genuine parts.
If the power supply cable of this device becomes damaged, it has to be replaced by a special power supply
cable available at your dealer.
Should you have further questions, please contact your dealer.

TECHNICAL SPECIFICATIONS

Power supply:
Power consumption:
Inputs:
Gain range:
Input impedance:
Frequency Response:
Outputs:
Output impedance:
Output gain range:
Maximum output level:
THD:
Delay:
Filters:
HPF:
LPF:
Slopes:
Type:
Equalizers:
PEQ:
LOSHF:
HISHF:
Q-value:
Gain:
Compressor:
Threshold:
Ratio:
Boost:
Limiter:
Threshold:
Attack:
Release:
Noise Gate:
Threshold:
Attack:
Release:
Dimensions (WxHxD):
Weight:
Please note: Every information is subject to change without prior notice. 06.09.2007 ©
90-240 V AC, 50/60 Hz ~
30 W
8/16, active, balanced
-40 dB to +6 dB
10 kOhms
20 Hz - 20 kHz
8/16, active, balanced
<50 mOhms (electronically balanced)
-40 dB to +6 dB
+20 dBu
0.01 %
0~1365 ms
10 Hz - 16 kHz
35 Hz - 20.2 kHz
6, 12, 18, 24 or 48 dB/octave
Bessel, Butterworth or Linkwitz-Riley
20 Hz - 20 kHz
20 Hz - 1 kHz
1 kHz - 20 kHz
0.4-128
±12 dB; 0.1 dB
-24 to +12 dB; 1 dB
1:128 to 128:128
x1, x2, x4, x8
-53 to +10 dB; 0.5 dB
20 Rs to 3 ms/dB
10 ms/dB to 5 sec/dB
-66 to -24 dB; 1 dB
0.1 ms to 100 ms/dB
10 ms/dB to 5 sec/dB
482 x 88 x 230 mm
7.2 kg
25/25 00029930.DOC, Version 1.0