Operating Determinations - Omnitronic DXM-0808 Operating Instructions Manual

OPERATING DETERMINATIONS

This device is a professional system-controller. This product is allowed to be operated with an alternating
current of 90-250 V AC, 50/60 Hz and was designed for indoor use only.
Do not shake the device. Avoid brute force when installing or operating the device.
When choosing the installation-spot, please make sure that the device is not exposed to extreme heat,
moisture or dust. There should not be any cables lying around. You endanger your own and the safety of
others!
The ambient temperature must always be between -5° C and +45° C. Keep away from direct insulation
(particularly in cars) and heaters.
The relative humidity must not exceed 50 % with an ambient temperature of 45° C.
This device must only be operated in an altitude between -20 and 2000 m over NN.
Do not operate the device in extremely hot (more than 30° C) or extremely cold (less than 5° C)
surroundings. Keep away from direct insulation (particularly in cars) and heaters.
Operate the device only after having familiarized with its functions. Do not permit operation by persons not
qualified for operating the device. Most damages are the result of unprofessional operation!
Never use solvents or aggressive detergents in order to clean the device! Rather use a soft and damp cloth.
Please use the original packaging if the device is to be transported.
Please consider that unauthorized modifications on the device are forbidden due to safety reasons!
Never remove the serial barcode from the device as this would make the guarantee void.
If this device will be operated in any way different to the one described in this manual, the product may suffer
damages and the guarantee becomes void. Furthermore, any other operation may lead to dangers like short-
circuit, burns, electric shock, etc.
Please note: This user manual describes the DXM-1616 as a reference. Illustrations and features of the
other models are comparable.
DESCRIPTION
Features
Digital matrix-controller
• 8/16 inputs and 8/16 outputs with flexible signal routing
• 48 kHz sampling rate
• 24 bit A-D/D-A-converter
• Integrated fully parametric equalizers or bell per input and output
• Slopes up to 48 dB/octave
• Backlit 2 lines x 20 character display
• 16 user programs can be memorized
• Up to 1365 ms signal delay for the inputs and outputs adjustable
• Independent compressor/limiter per channel with adjustable parameters
• Phase Invert per output
• Realtime Software Control über RS232, USB oder RS485 (Com)
• Minimum system-requirements: CPU 500 MHz or higher, VGA-card, 128 MB memory, 10 MB of free hard
disc space, CD-Rom drive, free COM-port, Windows XP, mouse
The OMNITRONIC system-controller is designed for professional application.
The OMNITRONIC DXM-0808/DXM-1616 is equipped with XLR input and output jacks.
18/25 00029930.DOC, Version 1.0