Maytag UMV1152BAB/W/Q/S Service page 34

Disassembly Procedures
!
W AR NIN G
Control Panel
FPC Connector(S1)
Relay 2
Model AMV5164A*B/W/Q
FPC Connector(S1)
Model AMV5164A*S
34
To avoid the risk of electrical shock, personal injury or
death; disconnect power to oven and discharge
capacitors before following any disassembly procedure.
Power
Transformer
(CN5)-For the sensor
model only
(CN1)
P.C. Board Removal
1. Disconnect oven power and remove grille, (see
(CN5)-For the sensor
model only
2. Remove control panel, (see "Control Panel"
Relay 2
3. Discharge high voltage capacitor, (see "High Voltage
(Relay 7)-White 4. Disconnect ribbon connector by sliding top part of
NOTE: Caution should be used when removing cable
(CN1)
5. Disconnect and mark the wire connectors from p.c.
6. Remove screws securing p.c. board to control panel
7. Reassemble in reverse order.
NOTE: Do not flex p.c. board.
16023056 Rev. 0
Control Panel
FPC Connector(S1)
Circuit Board
Models AMV5206A**, MMV5207A**, JMV8208A**
"Grille" procedure).
procedure).
Capacitor" procedure).
connector upward. Once in released position remove
ribbon from connector by siding ribbon side-to-side.
from connector. Ribbon cable has two holes
which connector locks ribbon in place.
board.
assembly.
Circuit Board
(CN3)
3 T ap
Power Relay
(RY7)
Power Transformer
(CN1)
©2004 Maytag Services