Maytag UMV1152BAB/W/Q/S Service page 55

Installation Instructions
STEP 6: Attach The Oven To The Wall
5. Roof venting installation: Install ductwork through the vent
opening in the upper cabinet. Complete the venting system
through the roof according to the method needed. See Figure
33. See PREPARE THE VENTING SYSTEM, STEP 2. Use
caulking gun to seal the exterior roof opening around the
exhaust cap. See Figure 6.
6. Use the power supply cord clamp to bundle the power supply
cord. Install the power supply cord clamp, using a screw as
shown in Figure 33, to inside of the cabinet.
7. Grasp filter screen with one hand holding the ring and the
other hand holding the opposite end. Insert the end of the
filter screen without ring into the opening and slide towards
the side of the microwave oven. Insert ring end of filter
screen into the opening and slide entire screen towards the
center of the microwave until screen is securely in position.
Repeat for other filter screen. See Figure 34.
8. Plug in the power supply cord.
9.
your microwave oven.
©2004 Maytag Services
18
16023056 Rev. 0
Figure 32
Figure 33
Figure 34
A – 15